Xplane12 Moza Ay210 Autopilot and trim follow

Is this the latest version of FFB-Bridge -1.4.1? If not, update and see if it helps. If it doesn’t, submit a support bundle and I’ll take a look.

Yeah man, with this 1.4.1 version. In support / health checks everything is green

Moza firmware is the last one

Yoke autocenter in Zibo is OFF

I try to remove some plugin but nothing change

Hmm k. Does AP follow work with other planes? The default Cessna for eg?

Or is it not working at all?

No the AP follow don't work with the default cessna .

i send to you the support bundle file

Thanks will take a look.

I believe I have a fix. I’ll share a diagnostic build with you tomorrow.

Thanks man I appreciate your help ! I wait them for test

Regards

Just sent you an email with a diagnostic build. Let me know if that helps.

OK man thanks a lot.. in 3 hour i return back to home and test it

Hey the build I sent you won't work; Zibo is a bit of an edge case. I'm working on something now.

I tested and don’t work . Ok let me know if you have any news! Thanks for this amazing support!

If it helps, setting up autopilot with Zibo is a challenge because without auto-trim follow, if you activate the autopilot it disengages. You have to move the yoke until it reaches the center point (back and forth movement searching for it), and then if you engage the autopilot it stays active.

If with autopilot On i move the Yoke , the autopilot don't disengage.

Try the build I just emailed you :)

I try the build and the yoke follow the autopilot. Same as the trim, if i trim up or down the yoke move forward or back...very small movement every trim click. Thanks man you are a legend! Tomorrow i test in a full flight with the Zibo!

Great, so working well now right? Let me know if you find any other issues.

i try them in a few flight..

• Autopilot follow - the yoke follow perfectly the aircraft yoke
• Trim follow - if with the yoke I pull towards me to gain altitude. I increase the trim (trim up) to ease the strain on the yoke. Nothing happens. So the trim follow doesn't work.

This will be improved in the next build.