Tłumaczenie automatyczne. Ta witryna i aplikacja FFB-Bridge są tłumaczone automatycznie — przepraszamy za ewentualne błędy. Poprawki do tłumaczenia aplikacji wysyłaj za pomocą jej wbudowanego narzędzia „Zgłoś tłumaczenie” oraz poprawki do tej witryny przez stronę opinii.
Tuning & how-to

Xplane12 Moza Ay210 Autopilot and trim follow

Odpowiedzi: 17 Wyświetlenia: 4654 rozpoczęto sie 16
#1

Hi guys,

i don't see any autopilot or trim follow from my moza Ay210 with Zibo737 Xplane12 . When i use the trim, the force on the yoke don't change and when i active the autopilot, the Yoke stay at neutral position

I use the profile for 737-800 and in the tuning/autopilot follow / all is at 100% and Enable is flagged.

Anyone can help me?

Zgłoś
#3

Yeah man, with this 1.4.1 version. In support / health checks everything is green

Moza firmware is the last one

Yoke autocenter in Zibo is OFF

I try to remove some plugin but nothing change

Zgłoś
#5

No the AP follow don't work with the default cessna .

i send to you the support bundle file

Zgłoś
#8

Thanks man I appreciate your help ! I wait them for test

Regards

Zgłoś
#9

Just sent you an email with a diagnostic build. Let me know if that helps.

Zgłoś
#10

OK man thanks a lot.. in 3 hour i return back to home and test it

Pomocne 1Zgłoś
#12

I tested and don’t work . Ok let me know if you have any news! Thanks for this amazing support!

Zgłoś
#13

If it helps, setting up autopilot with Zibo is a challenge because without auto-trim follow, if you activate the autopilot it disengages. You have to move the yoke until it reaches the center point (back and forth movement searching for it), and then if you engage the autopilot it stays active.

If with autopilot On i move the Yoke , the autopilot don't disengage.

Zgłoś
#15

I try the build and the yoke follow the autopilot. Same as the trim, if i trim up or down the yoke move forward or back...very small movement every trim click. Thanks man you are a legend! Tomorrow i test in a full flight with the Zibo!

Zgłoś
#17

i try them in a few flight..

  • Autopilot follow - the yoke follow perfectly the aircraft yoke
  • Trim follow - if with the yoke I pull towards me to gain altitude. I increase the trim (trim up) to ease the strain on the yoke. Nothing happens. So the trim follow doesn't work.
Zgłoś
#18
W odpowiedzi na post (autor: Alebrusch)
Trim follow - if with the yoke I pull towards me to gain altitude. I increase the trim (trim up) to ease the strain on the yoke. Nothing happens. So the trim follow doesn't work.
— Alebrusch

This will be improved in the next build.

Zgłoś